background image

Operator’s Manual

Viper® 99cc 4-Cycle Engine

23

For additional information email 

[email protected]

 or call 800-345-6007 M-F 8-5

ExPlaNaTION OF EmISSIONS CONTROl  

WaRRaNTY PROVISIONS

Viper Engines are designed, built and equipped to meet all EPA requirements.  

It warrants that it is free from defects in material and workmanship that could 

cause failure to the warranted part; and that it is identical in all material 

respects to the engine described in the manufacturer's application for 

certification. When a warrantable condition exists, Ardisam will repair your 

engine at no cost to you, including parts and labor.  The engine emissions 

label will indicate certification information.   If the purchaser is in need of 

a warrantable repair and is not within 100 miles distance from an Viper 

authorized repair center, Ardisam will pay for shipping costs to and from 

an authorized Viper repair center. 

Listed below are the parts covered by the emissions control systems 

warranty.  Some parts listed below may require scheduled maintenance 

and are warranted up to the first scheduled replacement point for that 

part.  Coverage under this warranty includes only the parts listed below (the 

emission and evaporation control systems) if so equipped:

•  Air Filter Assembly (only to the first scheduled replacement point)
•  Fuel Filter (only to the first scheduled replacement point)
•  Carburetor
•  Fuel Lines, Fuel Line Fittings and Clamps
•  Fuel Metering Valve (if equipped)
•  Evaporative System (if equipped)

 

  - Canister (if equipped)

 

  - Canister filter (if equipped)

 

  - Vapor hose (if equipped)

 

  - Orifice connector (if equipped)

 

  -Fuel tank

 

  -Fuel cap

 

  -Primer bulb canister (if equipped)

•  Spark Plugs
•  Magneto Ignition System 
•  Muffler Assembly

lImITaTIONS

The Emission Control Systems Warranty shall not cover any of the following:
a)   Repair or replacement required because of misuse or neglect, improper 

maintenance, repairs improperly performed or replacements not 

conforming to Ardisam specifications that adversely affect performance 

and/or durability and alterations or modifications not recommended or 

approved in writing by Ardisam.

b)   Replacement of parts and other services and adjustments necessary for 

required maintenance at or after the first scheduled replacement point;

c)  Consequential damages such as loss of time, inconvenience, loss of use 

of the engine or equipment, etc.

d)   Diagnosis and inspection fees that do not result in eligible warranty 

service being performed; and

e)  Any add-on or modified part, or malfunction of authorized parts due to 

the use of add-on  or modified parts.  

The warranty on emissions-related parts is as follows:

•  Any warranted part that is not scheduled for replacement as required 

maintenance in the owner's manual supplied, is warranted for the 

warranty period stated above.  If any such part fails during the period 

of warranty coverage, that part will be repaired or replaced at no charge 

to the owner.  Any such part repaired or replaced under the warranty 

will be warranted for the remaining warranty period.

•  Any warranted part that is scheduled only for regular inspection in the 

owner's manual supplied, is warranted for the warranty period.  Any 

such part repaired or replaced under warranty will be warranted for the 

remaining warranty period.

•  Any  warranted  part  that  is  scheduled  for  replacement  as  required 

maintenance in the owner's manual supplied, is warranted  for the period 

of time prior to the first scheduled replacement point for that part.  If 

the part fails prior to the first scheduled replacement, the part will be 

repaired or replaced at no charge to the owner.  Any such part repaired 

or replaced under warranty will be warranted for the remainder of the 

period prior to the first scheduled replacement point for the part. 

•  Add on or modified parts that are not exempted by the Air Resources 

Board may not be used.  The use of any non-exempted add on or 

modified parts by the owner will be grounds for disallowing a warranty 

claim.  The manufacturer will not be liable to warrant failures of warranted 
parts caused by the use of a non-exempted add on or modified part.

These items will be covered for a period of 

two years

 from the date of the 

original purchase.  Ardisam warrants that: the components are designed, 

built and equipped so as to conform with all applicable regulations adopted 

by the EPA; that they are free from defects in material and workmanship 

that could cause failure to the engine or other; and that the components 

used are identical in all material respects to the engine described in the 

manufacturer's application for certification.  The warranty period begins 

on the date the engine is originally purchased. 

maINTENaNCE aND REPaIR REQUIREmENTS

The owner is responsible for the proper use and maintenance of the engine.  

Viper recommends that all receipts and records covering the performance 

of regular maintenance be retained in case questions arise.  If the engine 

is resold during the warranty period, the maintenance records should be 

transferred to each subsequent owner.  Ardisam reserves the right to deny 

warranty coverage if the engine has not been properly maintained; however, 

Ardisam may not deny warranty repairs solely because of the lack of repair 

maintenance or failure to keep maintenance records.

Normal maintenance replacement or repair of emission control devices 

and systems may be performed by any repair establishment or individuals;  

however, warranty repairs must be performed by an Viper authorized service 

center.  Any replacement parts or service that is equivalent in performance 

and durability may be used in non-warranty maintenance or repairs, and 

shall not reduce the warranty obligations of the engine manufacturer. 

Содержание 13276

























Отзывы: