Manual VIPA System 300S
Chapter 1 Assembly and installation guidelines
HB140E - IM - RE_353-1DP01 - Rev. 14/46
1-5
SLOT1
DCDC
SLOT2
horizontal assembly
lying assembly
vertical
assembly
Please regard the allowed environment temperatures:
•
horizontal assembly:
from 0 to 60°C
•
vertical assembly:
from 0 to 40°C
•
lying assembly:
from 0 to 40°C
Approach
•
Bolt the profile rail with the background (screw size: M6),
so that you still have minimum 65mm space abov e and
40mm below the profile rail.
•
If the background is a g rounded metal or device plate,
please look for a low -impedance connection between
profile rail and background.
•
Connect the profile rail with the protected earth conductor.
For this purpose there is a bolt with M6-thread.
•
The minimum cross-section of the cable t o the protected
earth conductor has to be 10mm
2
.
•
Stick the power supply to the profile rail and pull it to the
left side to the grounding bolt of the profile rail.
•
Fix the power supply by screwing.
•
Take a back plane bus connect or and click it at the CPU
from the backside like shown in the picture.
•
Stick the CPU to the profile rail right from the power supply
and pull it to the power supply.
•
Click the CPU downwards and bolt it like shown.
•
Repeat this procedure with the peripheral modules, by
clicking a backplane bus connector, stick the module right
from the modules you've already fixed, click it downwards
and connect it with the backplane bus connector of the last
module and bolt it.
Danger!
•
The power supplies must be r eleased before installation and r epair
tasks, i.e. before handling with the power supply or with the cabling you
must disconnect current/voltage (pull plug, at fixed connection switch off
the concerning fuse)!
•
Installation and modifications only by properly trained personnel!
Assembly
possibilities
