Viola Symphony Manual Rev 1
4 of 15
9
th
September 2005
to 55°C non-condensing.
12.
ALWAYS
disconnect the unit from the mains supply during lightning
storms , or if the unit will not be used for a prolonged period.
INTRODUCTION
TRODUCTION
Thank you for choosing the VIOLA Symphony Amplifier. Great care has gone into
the design and manufacture of the Symphony and if properly used, it will give a
lifetime of musical enjoyment. We strongly recommend that you read these
instructions before you attempt to use the unit, so that you can be sure it is set up to
give optimum performance.
UNPACKING
The VIOLA Symphony Power Amplifier is heavy - the shipping weight is
approximately 120 pounds (55 kilograms). To avoid the risk of both personal injury
and damage to the product, do not attempt to lift it from its packing carton alone.
We recommend you use two people to unpack this amplifier safely.
Never attempt to lift the unit while bending from the waist. Always stand as straight
as possible and use your leg muscles to lift.
Please keep all of the packing materials in case you ever need to ship the unit.
Should you need to return the unit to the factory, you must use the original, shipping
carton. The use of any ot her packing may result in the product sustaining damage in
transit. Such damage is not covered by the warranty. Replacement shipping cartons
may be obtained via your VIOLA dealer, or directly from the factory.
After unpacking the unit, please confirm that the following items are present:
1 Viola Symphony power amplifier
1 user manual
1 three-conductor mains cord
If any of the above items are missing, or if the amplifier shows any signs of damage,
please contact your VIOLA dealer imme diately.
VOLTAGE SETTING
Before going any further please, confirm that the unit is set to operate on the mains
voltage you plan to use. The setting
is
marked on the unit’s rear panel above the
right hand fuse. If the setting on your unit is not correct, contact your VIOLA dealer.
Only a VIOLA approved technician should change the voltage setting. Do not
attempt to do this yourself. Should you set the unit to the wrong voltage, you risk
