VIO S218, Руководство пользователя

Страница: 37 / 53

37
VIO-S218 Cod. 420120267 REV. 0.1
10. RDNet NETWORK CONNECTION INPUT ("Data In")
For network cables with etherCON/RJ45 connectors.
Connect it to devices like RDNet Control 2 or Control 8 to use the remote control.
12. CONTROL LEDs
LEDs relating to module network operation (RDNet).
In particular, if "Link" is on the RDNet network is active and has acknowledged the device, if "Active" is flashing
there is data traffic, if "Remote Preset Active" is on all local control on the amplifier panel are by-passed by the
RDNet remote control.
English
11. RDNet NETWORK CONNECTION DAISY CHAIN ("Data Out")
Compatible with network cables with etherCON/RJ45 connectors.
It is used for the remote control network daisy chain to further system modules in daisy-chain configuration.
13. SERVICE DATA USB PORT
It is a mini-USB B port to be used only for product firmware update. For further information refer to " FIRMWARE
UPDATE ".
14. SYSTEM TEST
It carries out a test with sweep signal to check woofer integrity. This test must not be considered as thorough, but
just a first check in the analysis of any issues.
Table of the status LED signals
LED TYPE TURNING THE
SPEAKER ON
NORMAL
OPERATION GENERIC
WARNING SPEAKER SHUTS
DOWN DUE TO
MALFUNCTION
LIMITER OFF TURNED OFF,
TURNS ON ONLY
IN THE EVENT OF
INTERVENTION TEMPORARY
FLASHING CONTINUOUS CYCLIC
FLASHING
SIGNAL
OFF FLASHING IN THE
PRESENCE OF A
SIGNAL NORMAL SIGNAL
OF INPUT AUDIO OFF
MUTE/
PROT
TURNED ON FOR
A FEW SECONDS OFF TEMPORARY
FLASHING PERMANENTLY ON
READY OFF PERMANENTLY ON PERMANENTLY ON OFF
10 11 12
13
14