EN - Manual
5
The Safety Helmet has excellent durability and integrity. However, the protec-
tive capability may diminish over time due to wear and age.
PROTECTION
The Safety Helmet must fit properly to be effective. With a proper fit, the
helmet will not move back and forth or side to side while fastened.
This helmet is produced in 2 sizes: M & L. Size M is suitable for heads with a
circumference of 55-58cm and Size L for heads with a circumference of 58-
61cm. Try different sizes and choose the one which fits the best. The helmet
size can be adjusted by the adjustment ring at back of the helmet. If it still not
fit well try the other size helmet.
PAD FITTING
The Safety Helmet uses a quick-release buckle that is simple and can be
buckled and unbuckled without changing the adjustment. The straps must be
snugly and evenly tensioned. Place the helmet firmly on your head and fasten
the buckle. Notice which strap is loose. Tighten the loose strap after removing
the helmet. To tighten the chin strap, hold the buckle with one hand. Then pull
the excess strap through. (See Diagram A).
To tighten the rear strap, pull the excess from the rear of strap 2. Hold the hel-
met with one hand. With the other hand, hold the strap where it passes under
your chin. Then pull from side to side to balance the length of all four straps.
(See Diagram B). The helmet must fit sit firmly and level on your head. (See Di-
agram C) To lower the front of the helmet to cover your fore-head, tighten the
chin strap and loosen the rear strap. To raise the front, loosen the chin strap
and tighten the rear strap.
To check for proper tension, put on the helmet and fasten the buckle. Open
your mouth. You should feel the strap pulling against your chin. Then attempt
to pull the helmet off the front or rear. If the helmet comes off, increase strap
tension and re-evaluate the thickness of the inner pads. The helmet should not
be able to roll forward or backward excessively. It should not be possible to
remove the helmet without unfastening the buckle.
NOTE: Please check adjustment every time this helmet is worn.
RETENTION SYSTEM
