31
Tilt drag assembly
11
To remove the tilt drag assembly
11.1
Remove two screws (11) and three screws (19) securing the tilt drag assembly (25) to the
mechanism housing (10).
11.2
At the LH actuator (32), slacken screw (30).
11.3
Pull off the tilt drag assembly. Slight tapping of the tilt drag assembly may be required.
12
Limited dismantling of the tilt drag assembly is permissible. Proceed as follows
12.1 Carefully prise out the knob bung (47).
12.2 Remove screw (46) and washer (45). Pull off the drag knob (44). Remove two balls (48) and
springs (49). If required, pull out drag detent ring (43).
12.3 If required, remove snap ring (27) and pull off bearing (26).
12.4 If required, remove two dowel pins (28).
Balance mechanism
13
To remove/dismantle the balance mechanism, proceed as follows
13.1 Remove the platform
, spring-loaded flap
, tilt brake/balance knob/centre lock
and tilt drag assembly
, remove all base cover plates as follows:
13.2.1
Remove three screws (6) securing RH cover plate (7).
13.2.2
Remove three screws (6) securing LH cover plate (14). Disconnect and remove the
battery.
13.2.3
Remove four screws (6) securing brake lever guide assy (5) and brake lever cover
plate (4).
13.2.4
Remove two screws (6) securing switch cover plate (8). Remove screw (12) securing
PCB to base and carefully remove switch cover plate, PCB and battery connector. Note the
position of the LED and carefully manipulate it from its location
WARNING!: The tilt drag assembly is an hermetically sealed unit. Do not attempt to
dismantle the assembly beyond the level detailed below.
NOTE:
An extended 3 mm AF spherical-ended hex wrench (Vinten Part No.
) is
required to remove the tilt drag assembly.
Содержание Vector 700
Страница 1: ...Contents Nafl f Camera Control Solutions Next Page Previous View Vector 700 700H Black ...
Страница 10: ...10 Contents Previous Page First Page Next Page Previous View Design Improvements DETAILS SERIAL No INFORMATION ...
Страница 54: ...54 Contents Previous Page First Page Next Page Previous View ...