27
Bottom clamp
Using a suitable instrument, such as a flat-bladed screwdriver, carefully remove the hole plug
.
and washer
, but do not remove the clamp knob
.
Rotate the clamp knob
to ‘position 2’ shown in
, with the edge of the clamp knob
vertical. In this position the clamp is NOT fully rotated counterclockwise in the ‘off’ position.
Using a 2.5 mm hexagonal wrench, loosen the adjusting grubscrew
until the leg is free to
move under its own weight.
While sliding the leg in and out, gradually tighten the adjusting grubscrew
until the clamp
begins to grip.
Rotate the clamp knob
fully counterclockwise to the ‘off’ position and ensure that the leg is
free to move under its own weight.
Secure the clamp knob
. Refit the hole plug
Fig 10 Bottom clamp adjustment
(21)
(21.4)
(21.5)
(21.6)
(21.3)
P
O
S
IT
IO
N
2
POSITION 1
(21)
Содержание Protouch PRO-6 HDV
