14
Pan and tilt head
The PRO-5
plus
pan and tilt head
is supplied with a 75 mm ball mount. Adaptors are avail-
able which enable the head to be installed on tripods or pedestals fitted with other mountings.
These are listed under
To install the head, remove the bowl clamp assembly
from the head, position the head on the
tripod and refit the bowl clamp assembly from below. Level the head with the aid of the level bub-
ble
and tighten the bowl clamp
.
Mounting the camera
from the head by releasing the slide plate clamp
, pressing the
slide lock release
and lifting the plate upward.
Install the required camera fixing screw
in the slide plate and retain with the rubber bung
. Stow the unused screw in the appropriate stowage
in the platform.
Attach the slide plate
to the camera or camera mounting plate approximately under the centre
of the camera's weight using the fixing screw
(if appropriate).
Set the platform level and apply both the pan
and tilt brakes
.
Lower the camera onto the platform
ensuring that the edge of the slide plate opposite the
slide clamp engages first, and then push downward so the slide clamp ‘snaps’ into position.
.
Fig. 3 Mounting the camera
1
2
(15)
Содержание PRO-5Plus
