Instructions: Low Profile Post System
6. CONNECT THE POST
Slide the Post Top onto the c-Channel in the lower Post. It
may require a Rubber Mallet to connect fully (Figure E).
7. MARK CEILING/FLOOR AND PRE-DRILL
Align the first Post Assembly into desired location. Ensure
it is plumb with a level and mark the mounting holes. Set
the Post Assembly aside and pre-drill any required pilot
holes for your ceiling or floor mounting hardware (not
provided).
** Mounting Bases can be oriented perpendicular or
parallel to the Wine Racking. **
8. MARK AND PRE-DRILL POST
Starting from the bottom of the Post, lay the first Low Pro-
file Mounting Plate in the desired location and mark two
(2) mounting hole locations. Mark the holes for all other
Plates ensuring a minimum of 3-3/4” (96mm) vertical
clearance from one Plate to the next.
Use a Level or Square to ensure all Plates are Level. Set
Plates aside.
Using the provided Drill Bit, pre-drill all marked mounting
hole locations.
9. ASSEMBLE FIRST WINE RACK ROWS
Each Wine Rack Row assembly is comprised of two (2)
Low Profile Plates in one of three (3) widths (Figure G);
either two (2), four (4), or six (6) Wine Rods available
in three standard widths; and two (2), four (4), or six (6)
Evolution Screws.
Insert one (1) Evolution Screw per Wine Rod through
the first Low Profile Mounting Plate. Thread each
Wine Rod onto a Screw and fully tighten using pro-
vided 5mm Allen Key. Close the Wine Rack Row by
securing the open ends of the Wine Rods to the one
(1) Low Profile Mounting Plate using one (1) Evolu-
tion Screw per Wine Rod (Figure H).
Repeat this step to build the first three (3) Wine Rack
Row Assemblies.
Figure E
Figure F
Figure G
Figure H