Vintage Air 571065, Руководство пользователя

Страница: 14 / 24

14
www.vintageair.com
901305 REV C 9/26/2014, PG 14 OF 23
Locate evaporator drain on bottom of evaporator case.
In line with drain, measure 1” down and 2” to the left
and drill a 5/8” hole through the firewall
(See Figure 13, below).
Install drain hose to outlet on bottom of evaporator
unit, and route through the firewall.
Install 1/2” drain elbow onto drain hose.
Drain Hose Installation
1.
2.
3.
Figure 14
Figure 13
O-ring Installs
Over Male Insert
to Swaged Lip
O-ring
#6 O-ring
#8 O-ring
#10 O-ring
O-ring
Supplied Oil
for O-rings
Male
Insert
Female Nut
Hold With
This Wrench
Twist With
This Wrench
Lubricating O-rings
For a proper seal of fittings: Install supplied
O-rings as shown, and lubricate with supplied
oil.
NOTE: Standard torque specifications:
#6: 11 to 13 ft-lb.
#8: 15 to 20 ft-lb.
#10: 21 to 27 ft-lb.
Locate the #8 compressor A/C hose. Lubricate (2) #8 O-rings and connect the 90° female fitting to the #8
discharge port on the compressor. Then route the straight female fitting with R134a service port to the #8
condenser hardline coming over the core support. Tighten each fitting connection as shown in Figure 14, above.
Locate the #10 compressor A/C hose. Lubricate (2) #10 O-rings and connect the 45° fitting to the #10 suction
port on the compressor. Route the 45° female fitting with R134a service port to the #10 hardline on the inner
fender cap. Lubricate (2) #10 O-rings and connect the 90° female fitting in the wheel well to the #10 hardline
on the inner fender cap. Then route the straight female fitting from the inner fender cap to the #10 fitting on
the evaporator (See Figure 11a, Page 12 and Figure 15, Page 15). Tighten each fitting connection as shown in
Figure 14, above.
Locate the #6 evaporator A/C hose. Lubricate (2) #6 O-rings and connect the straight female fitting to the #6
hardline coming over the core support from the drier. Route the straight female fitting to the #6 hardline on
the inner fender cap. Lubricate (2) #6 O-rings and connect the 90° female fitting in the wheel well to the #6
hardline on the inner fender cap. Then route the 90° female fitting from the inner fender cap to the #6 fitting on
the evaporator (See Figure 11a, Page 12 and Figure 15, Page 15). Tighten each fitting connection as shown in
Figure 14, above.
A/C Hose Installation
1.
2.
3.
Standard Hose Kit:
Refer to separate instructions included with modified hose kit. 1.
Modified Hose Kit:
Drain Hose
2”
1”