Vintage Air 571064, Руководство пользователя

Страница: 14 / 24

www.vintageair.com
14
901304 REV D 02/28/2017, PG 14 OF 23
#6 Condenser/Drier
Hardline 101000
Heater Hose & Heater Control Valve Installation
1. In engine compartment, route a piece of heater hose from the water pump to the top heater fitting on the inner
fender cap (See Figure 13, below). Secure using hose clamps.
2. In engine compartment, route a piece of heater hose from the intake to the bottom heater fitting on the inner
fender cap (See Figure 13, below). Secure using hose clamps.
3. In wheel well, route a piece of heater hose from the top heater fitting on the inner fender cap to the top heater
fitting of the heater core as shown in Figure 9a, Page 11, and Figure 13, below. Secure using hose clamps.
4. In wheel well, route a piece of heater hose from the bottom heater fitting on the inner fender cap to the bottom
heater fitting of the heater core as shown in Figure 9a, Page 11, and Figure 13, below. Secure using hose
clamps. NOTE: Install heater control valve in line with intake manifold (pressure side) heater hose, and
secure using hose clamps as shown in Figure 13, below. Also note proper flow direction.
5. Apply a bead of silicone around each hose where it passes through the grommet on the firewall (See Figure
13, below).
Compressor Safety Switch (Binary
Type)
Screw-on Drier
(Refer
To
Condenser Instructions)
Flo
w
F
ig
u
re
13
From Intak
e
Manifold
From Ev
apor
ator
To W
ater Pump
Engine Side View of Inner Fen
der Cov
er
#8 Condenser/
Compressor Hardline
101002
#6 Drier/Co
re
Hardline 101001
(2)#10
Adel
Clamps
Apply
Silicone
Aro
und
Hoses
A
/C
&
H
ea
te
r
H
o
se
R
o
u
ti
n
g
#8 Discharge
Hose 106080
#6 Core
Hose 106077
NOTE: Vintage Air Systems Require (2) 5/8” Hose Nipples (Not Supplied)
Hose Clamps
From
Heat
er
Control
Valv
e
to
Ev
apo
rator
Heat
er
Hose
Heat
er H
ose
(H
eat
er
Co
ntrol
Valv
e/Int
ak
e)
#10
Compres
sor
Hose 106079
#6
Core
Hose 106077
#10 Compres
sor
Hose 106079
Evapo
rat
or t
o
Water P
ump
Heat
er
H
ose
(6) Tie W
raps
Heater
Control
Valv
e/Intak
e
Heater Hose
#6
Evapo
rat
or
Hose 106076
#10
Evapo
rat
or
Hose 106078
NOTE: Flow direction follows molded arrow on valve.