Vintage Air 571064, Руководство пользователя

Страница: 11 / 24

11
www.vintageair.com
901304 REV D 02/28/2017, PG 11 OF 23
#6 A/C
Hose
Hose
Clamps
Press
Tape
#10 A/C
Hose
Heater Hose
(To Water Pump)
Heater Hose
(To Heater Control
Valve, Then to
Manifold)
Drill 3/16” Holes in
Cowl After Leveling
To Water
Pump
To
Manifold
#10
#6
(2) 1/4-20 x 1”
Hex Bolts
(2) 1/4”
Flat Washers
(2)#14 x 3/4”
Hex Sheet Metal
Screws
NOTE: After installing #10 suction line,
wrap all exposed metal (fittings & tube)
with supplied press tape.
Figure 9
Install A/C and heater hoses (See Figure 9a, below).
Lift evaporator unit up under the dashboard. Secure loosely to firewall using (2) 1/4-20 x 1” hex bolts and flat
washers (See Figure 9, below). NOTE: To ensure proper drainage, it is very important that the evaporator
is level, both left-right and fore-aft. Check for level on the flat portions of the case around the drain.
Using front evaporator bracket as a guide, mark and drill (2) 3/16” holes in cowl (See Figure 9, below).
Using (2) #14 x 3/4” hex sheet metal screws, secure the front evaporator mounting bracket to the cowl (See
Figure 9, below).
Verify that evaporator unit is level and square to the dash; then tighten all mounting bolts. NOTE: Tighten the
bolt on the firewall first. Then tighten the front mounting bracket.
Evaporator Installation
1.
2.
3.
4.
5.
Figure 9a
NOTE: To ensure a watertight seal between the passenger compartment and the vehicle exterior, for all
bolts passing through the firewall, Vintage Air recommends coating the threads with silicone prior to
installation.
NOTE: Coat bolt threads
with silicone prior to
installation.