Vintage Air 1968 CUTLASS, Руководство пользователя

Страница: 11 / 28

11
901091 REV A 3/29/12, INST 1968 CUTLASS wo AC EVAP KIT PG 11 OF 25
EVAPORATOR INSTALLATION
ON A WORK BENCH INSTALL (2) HEATER FITTINGS WITH PROPERLY LUBRICATED O-RINGS. (SEE FIGURE 14,
PAGE 14, AND FIGURE 10 PAGE 12.)
INSTALL EVAPORATOR FRONT & REAR MOUNTING BRACKETS ON EVAPORATOR USING (6)1/4-20 x 1/2
HEX BOLTS AND TIGHTEN AS SHOWN IN FIGURE 9 BELOW & FIGURE 10, PAGE 12.
LAY EVAPORATOR SUBCASE ON PASSENGER SIDE FLOOR
BOARD. INSTALL A/C & HEATER HOSE ON
EVAPORATOR AS SHOWN IN FIGURE 14, PAGE 14
AND FIGURE 11, PAGE 13.
(NOTE: WRAP THE #10 FITTING CONNECTIONS
WITH PRESS TAPE. SEE FIGURE 11, PAGE 13.)
(2)1/4-20 x 1/2
HEX BOLT
FRONT
EVAPORATOR
BRACKET
644100
FIGURE 9
FIREWALL COVER INSTALLATION
APPLY A 1/4” BEAD OF SILICONE AROUND THE BACK SIDE OF THE FIREWALL COVER AS SHOWN IN
FIGURE 8, BELOW.
FROM INSIDE THE CAR, INSTALL FIREWALL COVER ON FIREWALL USING (3) 1/4-20 x 1” HEX BOLTS, (3) FLAT
WASHERS AND (1)1/4-20 NUT WITH STAR WASHER, SEE FIGURE 8, BELOW.
NOTE: USE SEAM SEALER OR SILICONE TO FILL GAP BETWEEN COVER AND LIP IN FIREWALL BEFORE
PAINTING.
BACK SIDE
OF FIREWALL
COVER
SILICONE
(3) 1/4-20 x 1”
HEX BOLT
1/4” NUT
w/ STAR WASHER
FIREWALL
COVER
644109
HOLES
NOT USED
(4) 1/4 x 3/4
FLAT WASHER
1/4 x 3/4
FLAT WASHER
FIGURE 8