-6-
Temperature and Humidity
1. The controller
Fig. 2 TEMPERATURE CONTROLLER
1) Keys
SET:
To display set-point; in programming mode it selects a parameter or confirms
an operation.
:
To start a manual defrost.
:
To see the maximum stored temperature; in programming mode it browses
the parameter codes or increases the displayed value.
:
To see the minimum stored temperature; in programming mode it browses
the parameter codes or decreases the displayed value.
:
To turn on/off the power to the unit.
+
:
To lock/unlock the keypad.
SET+
:
To enter in the programming mode.
SET+
:
To return to the temperature display.
2) Lock and unlock the keys
To lock the keys, press up + down keys + until POF is displayed; to unlock
the keys, press up + down keys. + until PON is displayed.
3) Display
During normal operating conditions, the display shows the value measured by
the air temperature probe. In case of active alarm, the temperature flashes
alternately to the code alarm. The LED functions are listed as follows.
LED
MODE
FUNCTION
ON
Compressor enabled
Flashing
Anti-short cycle enabled
ON
Defrost enabled
ON
Fan enabled
Flashing
Fan delay after defrost
enabled
ON
Alarm occurring
ON
Temperature measuring unit
Flashing
Programming mode
Содержание Wine-Mate WM-1500SSI
Страница 10: ...9 FoF fan off with compressor off min 15 NOTE Depending on the controller not all parameters are available...
Страница 18: ...17 Fig 3 Temperature Controller 4 5 L X 4 5 W X 3 75H Fig 4 WM 15 45SFCI Evaporator Unit...
Страница 28: ...27 Fig 15 WM 1500 4500SSI LA Electrical Wiring Diagram...
