Vinotemp WINE-MATE WM-12000SSH, Руководство по установке операции "Забота"

Страница: 19 / 32

- 18 -
Fig. 7 WM-Liquid Filter Fig. 8 WM-Liquid Indicator
2. Temperature Controller and Air Probe Location
1) The temperature controller can be mounted either inside or outside the wine
cellar, but the air probe must be located inside the wine cellar or the return
duct.
2) The air probe shall be located in the wine cellar 5 ft above the floor or the air
return area, but it shall not be located in the air supply area or other areas
where air is not circulated.
3) Air probe can be pulled out of the temperature controller up to 5 ft. If
additional wires are necessary, 18 gauge wires may be used to extend the air
probe.
4) If the air probe is installed in a return duct, the evaporator fans shall be
running all the time. Meanwhile due to the temperature differential the air
probe calibration should be done in order to maintain the proper wine cellar
temperature.
3. Evaporator Unit Location
1) WM-25~120SFCH evaporator units can be installed outside a wine cellar. It
shall not be exposed to temperatures higher than 85 °F.
2) Air supply shall be unobstructed minimum 12”; air return shall be
unobstructed minimum 6”.
3) There is a gravity drain system, so the unit shall be installed level or with a
slight slope downward the drain connection and the drain line shall be
installed slope down toward the drain.
If rise-up is necessary, a condensation pump must be used.
4) Secure the ducts with conduits to the cellar exterior walls and make sure they
are not curled, twisted, bent and clogged.
Model No. Insulated Duct
WM-2500SSH
WM-2500SSH-LA
8”
WM-4500SSH
WM-4500SSH-LA
8”
WM-6500SSH
WM-6500SSH-LA
10”
WM-8500SSH
WM-8500SSH-LA
10”
WM-12000SSH
WM-12000SSH-LA
10”