INSTALLATION INSTRUCTIONS
Before Using Your Unit
•
Remove all packing material before using your refrigerator.
•
Check to be sure the appliance is in good condition and that you have all of the following
parts:
o
3 chrome-plated wire shelves
o
1 wire basket
o
1 instruction manual
•
Use a soft, dry cloth to wipe down the outside of the refrigerator thoroughly. Clean the
interior surface with a soft cloth and lukewarm water.
IMPORTANT:
Before connecting the unit to a power source, let it stand upright for
approximately 24 hours. This will reduce the possibility of malfunction in the cooling system
from handling during transportation.
Locating Your Unit
•
Position the refrigerator in a dry and well-ventilated place. Avoid placing the refrigerator near
any source of heat or moisture, or in direct sunlight. The recommended ambient
temperature should be between 25° and 100°F.
•
The refrigerator is designed to be free-standing or built-in. The bottom front vent of the unit
should be free of obstruction.
•
Place your refrigerator on a solid, level surface (other than carpet). This will ensure vibration
and noise-free operation.
•
When positioning the refrigerator, leave a minimum clearance of ½ an inch at the back of
the unit, 1 inch at the top of the unit and ¼ inch on both sides. This is to ensure proper
circulation.
NOTE:
Upon plugging the refrigerator into an electrical outlet, let the unit run for at least 30
minutes before making any adjustments.
Installing the legs or casters
Four casters are provided with the refrigerator. They are ideal for rolling the unit from place to
place outdoors. Use two or more people when installing or removing casters or legs.
1. Tip unit to the right so there is a ¾-foot clearance at the left of the unit.
2. Remove the leveling legs, and tighten one of the casters with lock in the front screw
hole and tighten one of the casters without lock in the back screw hole.
3. Repeat the two steps above with the exception of tipping the unit to the left now, to
tighten the other two casters. The casters are now installed.
4. The unit should be level. If the floor conditions do not allow the unit to sit level, adjust
the wheel by turning it counter-clockwise to increase the height and clockwise to
reduce the height.
7
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
