Vinotemp VT-36, Руководство пользователя

Страница: 10 / 16

10
W W W . V I N O T E M P . C O M
INSTALLING THE HANDLES
•
Pull away the door gasket in the area where the handle is to be installed. The gasket is easily
removed by hand, no tools are necessary.
•
Insert the two (2) Phillips head screws with the lock washers and flat washers through the gasket
side of the door frame until the screws pass through the door frame. Follow the sequence shown
in the figure.
•
Align the handle with the screws installed in the above step. Tighten the screws using a Phillips
head screwdriver until the handles secure tightly against the door frame. (Do NOT over tighten as
this will cause damage to the handle assembly).
•
Replace the door gasket to its original position.
Handle
Door Frame
Gasket
Screw
Lock Washer
Flat Washer
OPERATING YOUR WINE COOLER
LEFT ZONE PANEL RIGHT ZONE PANEL
POWER
Powers on/off the appliance. To turn off the appliance, touch the mark and hold 5 seconds.
LIGHT
To control the interior light turn on/off.
UP
Used to raise (warm) the corresponding zone set temperature by 1°C or 1ºF.
DOWN
Used to lower (cool) the corresponding zone set temperature by 1°C or 1ºF.
ºF/ºC
Selector
Selects the temperature display setting to display in Fahrenheit or Celsius degree.
SETTING A TEMPERATURE
•
The left zone temperature can be set between 36° and 43°F, and the right zone temperature can
be set between 40° and 72°F.
•
The temperature will increase by 1°C or 1ºF if you touch UP once, or the temperature will