Keeping Spout Clean
•
Use the spout cap to cover it if the unit is not in use.
•
To remove the cap, press the release ring while pulling
the cap.
Replacing Stopper-Dispenser
NOTE:
Replace the stopper-dispenser with a new one If it is damaged, All pipe thread
connections require Teflon sealant.
•
Disconnect both gas and wine coupling plugs and sockets at the stopper-dispenser.
•
Loosen the stopper-dispenser from the bottle neck.
•
Remove the gas coupling socket by turning 1/8” NPT counter-clockwise.
•
Remove the wine coupling socket by turning 1/4” NPT counter-clockwise.
•
Remove the inline filter by turning 1/4” NPT counter-clockwise.
•
Use the reverse steps to install the loosened parts on the new stopper-dispenser.
CARE INSTRUCTIONS
Unplug the unit before performing any maintenance or cleaning.
Removing Condensate
•
The unit is operated with an automatic defrost cycle. The condensate collects in
the drip tray that is located in the compressor compartment. Normally, the
condensate evaporates by the hot gas tubing.
•
Check the drip tray occasionally and remove extra condensate if it begins to fill
due to high humidity conditions.
W W W . V I N O T E M P . C O M
24
Содержание VT-100 WINEDISP4
Страница 30: ...W W W V I N O T E M P C O M 30...
