Vinotemp Element EL-BWC108-SS, Руководство пользователя

Страница: 8 / 24

INSTALLATION
§ Remove all packing material before using your wine cooler.
§ IMPORTANT : Before connecting the unit to a power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
§ Clean the interior surface with
lukewarm water and a soft cloth.
§ This unit is designed for freestanding
and built in installation and indoor use only.
Position the unit in a dry and well-ventilated
place. Avoid placing the wine cooler near
any source of heat or moisture, or in direct
sunlight. Do NOT install the unit in a
location with an ambient temperature that
will fall below 60°F
.
§ For built-in installation, leave a 1/4”
(6.35mm) space on each side and at
the top of the wine cooler to ensure
proper air circulation to cool the compressor
and condenser. Also, be sure to not obstruct
the front exhaust vent with any objects as
this may affect the unit from performing
properly.
§ For freestanding installation, leave
3.15” (8cm) of space at the back, 2” (5cm)
of space on each side, and unlimited
clearance at the top of the wine cooler are
suggested to ensure proper air circulation to
cool the compressor and condenser. Do not
place underneath a table, counter top, or
anything of the sort as this will not allow for
proper air circulation.
§
Do not slide the unit into place. When
moving your wine cellar, please do not
incline it more than 45 degrees.
§ Place the wine cooler on a flat, level surface strong enough to support it when it is fully loaded. To level the
appliance, adjust the front leveling legs at the bottom of the unit.
§ For best performance it is recommended that you install the appliance in a location with an ambient
temperature range between 64-78°F (18-26°C) . If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected.
§ It is recommended that you do not install the appliance near an oven, radiator or other heating source. Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Don’t install in a
location where the temperature will fall below 60°F (16°C). For best performance, do not install the appliance
behind a cabinet door or block the base grille.
§ Avoid locating the unit in moist areas.
§ Plug the beverage cooler into an exclusive, properly installed-grounded wall outlet.
§ After plugging the appliance into a wall outlet, please allow the unit to cool down for 3 to 4 hours before placing wine
bottles or beverage cans inside.
8
77 in (1956mm) 77 1/4 in (1962mm)
23 3/4 in (603mm)
24 1/4 in (616mm)
***Add 1/4” (6.35mm) on both sides and at the top,
plus 1” (25mm) in the back for built-in installation
28 5/8 in (727mm)
29 5/8 in (752mm)