IN CASE OF 4CYCLE ENGINE
FRONT VIEW
A B
. Drill the hole for PP pipe.
. Insert the Z bend into the hole on
throttle lever of your engine.
. Use epoxy glue to secure the PP
pipe on fire wall.
9-Engine
Side view
To throttle
servo
135 mm
10-Engine
IN CASE OF 2 CYCLE ENGINE
FRONT VIEW
Cut
here
Cut
here
Engine thrust on balk head is already adjust at factory.
Step 3
Cut here
Cut here
Step 5
Side-Bottom view
Step 1
Step 2
Ply engine mount plate
Align the mark on both mounts
with the mark on the ply engine
mount plate
Step 4
1.5mm
A B
!
CA
L/R
Assemble left and right
sides the same way.
X
Drill holes using the stated
size of drill
(in this case 1.5 mm Ø)
Use epoxy glue
Take particular care here
Hatched-in areas:
remove covering
film carefully
Not included.
These parts must be
purchased separately
Check during assembly that these
parts move freely, without binding
Apply cyano glue
