Vingtor AACM-144-V10, Руководство по установке и настройке

Страница: 38 / 76

38
A100K10647
ACM Family - System Installation & Configuration
7.3 Configure IP Address
o onne t t e ACM e ange to your I net or you nee to enter t e
IP settings for the Ethernet ports and IP route entries according to the
network. See
Section 5.3 ACM Programming and Cable Reference List
for IP settings to use.
Set IP address for Ethernet port 0 and/or 1
Log in to ACM via AlphaWeb
Select System Configuration >
Interfaces
Enter the IP address
Enter the subnet mask
Click Save to save the values
1
Do NOT click Apply until all address, routing and filter
changes have been saved!
Set IP Routes
Route type host is used to set up a route to a single device outside
the subnet of ACM.
Route type net is used to set up a route to another network.
Route type default is used to set up a general route to any device
outside the subnet of ACM.
Select System Configuration > Routes
Select the type of IP route by clicking Add Route
- Default IP route
Enter only Gateway (IP address) and Out Interface Ethernet port
(eth0/1)
Network route
Enter Destination IP a ress Destination Mask Gateway and Out
Interface Ethernet port (eth0/1)
Host route
Enter Destination IP a ress Gateway and Out Interface Ethernet port
(eth0/1)
Click Save and Apply to apply changes