Vincotech 2xflowSCREW4w, Инструкция по эксплуатации

Страница: 9 / 18

flowSCREW 4w packages
Copyright Vincotech
Handling Instruction
03 rem. sect. 5.2; mod. at sect. 5.1 29.09.2014
Gyimóthy Zs.
Gyetvai T.
FSWB-M-*-HI
Page
9 /
18
02 remove section 6.2 14.05.2014
Gyimóthy Zs.
Gyetvai T.
01 20.02.2014
Gyimóthy Zs.
Gyetvai T.
Ver. Alteration Date Des. / Mod. Appr.
6 Screw and torque specifications for fastening the module to the
heatsink

M5 screws (The recommended screw type is DIN 7984.)

Flat washer: D = max. 10 mm, ISO 7092 (DIN 433)

Spring washer: D = max. 10 mm, DIN127 or DIN 128

Mounting torque: 4 Nm < Ma < 6Nm

Thread length into the heatsink: min. 9 mm (depending on the material properties of the
heatsink and screw)
Tighten screws in the sequence given below and shown in Figure 9 :
1) Attach the module loosely with two diagonal screws, e.g. 1&3, 1&4 or 1&5.
2) Tighten screws with 0.5 Nm torque in the following sequence:

flowSCREW4w : screw 1
– 4 – 2 – 3

2x flowSCREW4w : screw 2
– 5 – 1 – 6 – 3 – 4

3x flowSCREW4w : screw 2
– 7 – 3 – 6 – 1 – 8 – 4 – 5
3) Tighten the screws with 5 Nm torque in the same sequence.