Vincent
3
35
5
BASIC FUNCTIONS AND SETTINGS
OPERATING THE APPLIANCE
Operation
Button(s) Description
Switch on and off
POWER (1)
The amplifier is switched on and off using this button at the front panel,
there is no standby option. When switched off the device is internally
separated from the AC power. As a precaution, after switching on, the
volume setting of your system’s amplifier should be reduced.
Change the level of the
analogue audio outputs
(10) at the rear panel
VOL + (29)
VOL – (30)
This function may only be activated with the remote control and only during
playback. This control is to allow the adaptation of the player to the system
(mainly the amplifier) and it must not be used to change the volume of the CD
player in daily use. It is sufficient for almost all amplifiers/receivers/preamplifiers
to put the setting to the maximum and to leave it there. A different value is only
used if the CD player is much louder compared with the other sources at the
amplifier/receiver or it is distorted (clipping). Hold down the “VOL+” button to
raise the output level. Use the “VOL-” to reduce it. The two-figure value of the
volume appears in the display. The maximum signal level is reached with a set-
ting of 26 and the minimum is at 00. This volume control changes the output
level of all analogue outputs to the same extent.
Change the brightness of
the front panel display
DIMMER
(13)
This function can only be operated using the associated front panel button.
When repeatedly pressed, the display (2) brightness is periodically reduced
(1x), switched off (2x) and restored to the original, maximum brightness (3x).
