Vimco LUTRON Sivoia SV-MDU-HT-W-L, Инструкция по установке и эксплуатации

Страница: 12 / 16

Page 12
shading solutions by
VIMCO
TM
MDU WITH SV-IR INFRARED RECEIVER MODULE
Sivoia
®
system covered by
decorative valence
The SV-IR allows the MDU to be controlled directly with a Sivoia
®
Infrared Handheld Transmitter (SV-OCIT, SV-3PIT,
SV-4S2G-IT, or SV-4GD-OCIT). The SV-IR receiver connects to the MDU via a 20 in. (51 cm) cable. This provides the
SV-IR receiver ample mounting range to offset most infrared signal restrictions caused by a protective/decorative
covering for the shade system. To extend the IR receiver mounting range, add up to five (5) SV-IR-EXT-10 extension
cables (10 ft. [3 m] each).
Note: To control an individual shade with an IR transmitter, the SV-IR must be connected to that MDU. If there is a
Group/Subgroup of MDU’s with the same Room/IR Address (see page 11),the SV-IR need only be connected to
one of those MDU’s to control the entire Group/Subgroup.
- The SV-IR receiver must be located to allow line-of-sight reception of infrared signals.
- The SV-IR has a range of 30 ft. (9 m) when receiving infrared signals.
- The SV-IR must
NOT be located near lighting fixtures or in direct sunlight.
- The SV-IR must be located within 50 ft. (15 m) of the MDU it is connected to. Add up to five (5) SV-IR-EXT-10
extension cables (10 ft. [3 m] each).
MDU
SV-IR Infrared Receiver Module
8