11
TAB: 40607
EN
Initial switch-on
The suitably wired and powered device shows, when not configured, the following screen on which are shown: IP address (au
-
tomatic link-local address temporary), MAC address, system ID, firmware version. By default, all the devices have ID 00.00.000
that is a non-specified ID: to simplify system configuration via
Video Door IP Manager
, the installer can set the ID on each
device. Press
Change ID
and on the next screen assign the ID: select an unequivocal ID for each user; assign the same ID to
all the video entryphones belonging to the same user.
When installing a KIT, setting the ID is unimportant: follow the instructions in the following section to activate the KIT. On the
other hand, the installer must finish configuring and activating the device via the Video Door IP Manager software (refer to
the VDIPM documentation).
When installing a KIT, setting the ID is unimportant: follow the instructions in the following section to activate the KIT. On the
other hand, the installer must finish configuring and activating the device via the Video Door IP Manager software (refer to
the VDIPM documentation).
40607_49400925a0_Quik Guide_01.indd 11
27/09/2017 16:39:07
