Vimar 8013406205636, Руководство по установке

Страница: 16 / 32

16
EN
69AM/T
3. Hardware configuration
Reference is made to CN10 positioned to the upper left hereafter.
3.1. BUS TERMINATION
On the upper left side, under CN10, is connector CN1. A
jumper in one of the three possible positions A-B-C makes it pos-
sible to terminate the bus correctly as regards the video signal.
Try the condition that allows the best vision as a compromise (see
the table in the wiring diagrams section).
3.2. VIDEO TERMINATION
When closed, jumpers CN3, CN4, CN6 and CN7 insert a ter-
mination at 75 Ohm for each of the four possible video signals.
The terminations are obviously independent (already inserted
by default).
Programmer 950C button
layout
4. Software configurations
The configurations can be made using programmer 950C con-
nected to CN9 situated at the top right and which is also acces-
sible from outside the cover.
Alternatively, using interface 692I/U and the software complement
for PC SaveProg.
The configurable parameters are described in Table A below:
4.0 IDENTIFICATION ASSIGNMENT
The identification is assigned via software programming.
The switch can be identified as an entrance panel or as a device
and as a CCTV for switchboard.
To identify it as an entrance panel, see paragraphs 4.2 and 4.3.