Vimar 40605, Руководство пользователя

Страница: 16 / 30

16
TAB: 40605
EN
also configure the time zone, time format (12 or 24 hours) and date format.
4.2 Display and Buttons
•
Sound Buttons : to activate/deactivate sound feedback when pressing buttons and the screen.
• Button Brightness : to adjust the brightness of the button backlighting.
• Standby Button Light : to enable/disable button backlighting in standby.
• Display Brightness : to adjust the brightness of the display.
• Shutdown Timeout : to set the amount of idle time before standby.
4.3 Sounds
•
Ringtones : to select the desired ringtone based on the type of call received. There are ten ringtones to
choose from. The call types are: from External Unit, from Porter (porter switchboard), from Users (other
system users), Intercom (call from another of the user’s devices), Bell (call via dedicated Landing call
input).
• Ringtone Volume : to adjust the ringtone volume (same for all call types).
• Button Volume : to adjust the volume of the button press sound effect.
4.4 Call Options
•
End Call
With
Key Button
: if this option is enabled, when receiving a call from External Unit, pressing the
Key button activates the External Unit lock and simultaneously cuts off the call (even during conversa-
tion).
• Video Voicemail Start Timeout (from master device only): to set the standby time in seconds before
the voicemail service (if activated) is triggered when a call is unanswered. If the user status is Do Not
Disturb and the service has been activated, the voicemail function will start immediately when a call is
received.
• Video Voicemail Message (from master unit only): record and listen to the introductory message of the
voicemail service (length 10 seconds). When the voicemail service activates, this message is played
by the calling device before recording starts.
4.5 System
•
Firmware Version : version of the video entryphone’s firmware.
•
IP Address : IP address (and MAC address) of the video entryphone.
• Restart : to restart the device.
• Reset Settings : to restore all user settings to the default configuration, except for Names . For these,
use the dedicated command Reset Names in the General section.
• Factory Reset : to restore all settings to the factory configuration. The administrator password must be
entered to perform this operation. CAUTION: the assistance of the installer will be required to reconfigure
the video entryphone and make it usable again.