Vimar 2906, Инструкция по эксплуатации

Страница: 10 / 28

8
5.1 Fitting and replacing the SIM card
The thermostat can be used with a traditional SIM card (ID-000 format) for voice / SMS traffic; data SIMs
cannot be used for operating the device .
To install the SIM card:
• Disable the PIN code from the SIM card (install the SIM in a mobile phone and when switching on disable
the PIN code prompt).
• Turn off the power supply to the thermostat 02906.
• Remove the front panel by inserting a screwdriver into the slot in the bottom and pushing the release tab
upwards and, at the same time, pull out the front of the product.
• Insert the SIM card into the SIM holder in the rear of the front panel you have just removed.
• Fit the front panel back into its original position by hooking it onto the mounting tabs located on the upper
side of the part on the wall and then closing the lower part. Finally, power up the thermostat.
• The icon will show the correct installation and the quality of the GSM network:
blinking: switch-on phase (if the icon is still flashing after a few minutes, it means that there is an ERROR so it is
necessary to check the SIM card)
: GSM signal not present or insufficient
: GSM signal barely sufficient (up to 20%)
: GSM signal from 20% up to 50%
: GSM signal from 50% up to 80%
: optimum GSM signal (over 80%)
OPEN
LOCK
3 4
OPEN
LOCK
OPEN
LOCK
1 2