Villager VTB 375, Оригинальное руководство пользователя

Страница: 23 / 122

Villager VTB 375 (GB)
10
Intended use
The machine is intended for private use and must not be used professionally.
Refuelling
Refuel as follows:
1.
Clean round the fuel cap.
2. Unscrew the fuel cap.
3. Refuel by using a funnel, or use a filler can with spout so that no fuel is
spilled.
4. Screw on the fuel cap.
5. Move the Petrol tiller at least 3 metres from the refuelling point before
starting it.
Starting
NOTE:
Always check the oil level before starting. Otherwise there is a risk of
serious damage to the engine.
Start the machine as follows .
Start the machine as follows:
1.
Fold up the transport wheel by first pulling it forward, lifting it up and then
locking it with the pin in the top position.
2. Set the throttle control to full throttle
3. Check that the blades are at a safe distance from any onlookers before
starting the machine.
4. Hold the handlebars with one hand and slowly pull the starter handle with
the other hand. When the starter engages, pull the starter handle quickly
and firmly until the engine starts.
NOTE: Do not pull the cord hard against its end position and do not allow it
to snap back. This can damage the starter.
5. Set the throttle control in the required position. See above.
6. Set the spur to the required depth by pulling out the pin, adjusting the depth
of the spur and then replacing the pin.
7. Press down the clutch handle to run forwards. Pull down the safety pin and
turn it to another angle before pressing in the clutch handle to activate the