Villager VLP 407, Оригинальное руководство пользователя

Страница: 30 / 155

13
NOTE: When clamping thin section metal diamond discs, the outer flange must be reversed
so that the flat/dished side screws against the disc hub.
Press and hold down the spindle lock button and tighten the outer flange using the two pin
locking wrench. It may be necessary to turn the spindle to fully locate the spindle lock
button.
When the outer flange washer is tight, release the spindle lock button and remove the
wrench.
4. SWITCH (see fig 4)
The On/Off trigger switch is sprung in the OFF
position. The angle grinder is started by pushing
forward the on/off switch. See fig 4. To stop the
angle grinder, release the on/off switch and it will
return to the OFF position.
WARNING! The disc will continue rotate
for a few seconds after the angle grinder has
been switched off.
Always wait until the disc has stopped
completely before putting the angle grinder
down. Do not attempt to operate the spindle lock
button while the disc is still rotating.
5. TO USE GRINDER (see fig 5)
Attention: Do not switch the grinder on whilst the
disc is in contact with the workpiece. Allow the
disc to reach full speed before starting to grind.
Hold your angle grinder with one hand on the main handle and other hand firmly around
the auxiliary handle.
Always position the guard so that as much of the exposed disc as possible is pointing
away from you.
Be prepared for a stream of sparks when the disc touches the metal.
For best tool control, material removal and minimum overloading, maintain an angle
between the disc and work surface of approximately 15°-30° when grinding. Exert light
pressure on abrasive discs for efficient operation. Pushing too hard will cause a drop in
speed and may result in motor overload and damage.
Fig 5
Fig 4
On/Off switch
button