Villager VLN 470, Оригинальное руководство пользователя

Страница: 34 / 164

Villager
VLN 470 (GB)
16
Overload
The motor of your right angle grinding machine may be damaged when overloaded.
This results from excessive working pressure over a prolonged period. Therefore you
should not try to accelerate your working speed by increasing pressure on your
machine. The abrasive disks work more efficiently if only slight pressure is exerted on
the grinding machine, thus avoiding a drop in the grinding speed.
Check the delivery parts
Carefully remove the tool from its packaging and check if the following parts are
complete:
1 x Side handle
1 x grinding protective cover
1 x spanner
Maintenance / Cleaning / Lubrication / Storage
Maintenance
Always be sure that the tool is switched off and unplugged before attempting to
perform inspection or maintenance.
If the carbon brushes need to be replaced, have this done by a qualified repair person
(always replace the two brushes at the same time)
If the supply cable is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
Cleaning
The tool and its air vents have to be kept clean. Regularly clean the tool’s air vents or
whenever the vents start to become obstructed.
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible
to damage from various types of commercial solvents and may be damaged by their
use. Use clean clothes to remove dirt, carbon dust, etc.
Lubrication
All the bearings in this tool are lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions, therefore no
further lubrication if required.