Villager VDS 625, Оригинальное руководство пользователя, Страница: 30 / 145

13
Villager VDS 625 (GB)
Attaching and changing sanding disc ③
- Place the sanding disc in the center of the sanding pad and press on. The holes
in the sanding disc must be in alignment with the extraction holes in the
sanding pad.
- For round sanding pad only: conduct a test run to check that the sanding disc is
clamped in the centre.
Extension shaft (optional) ④
- Use the extension shaft (o) according to the intended operation for higher work
surface.
- Loosen the sleeve on the dust extraction outlet (I) of the upper shaft (F). Do not
remove the sleeve from the outlet.
- Align the rear handle (o1) with the main handle (B) and insert the sleeve (o3) on
the extension shaft (o) into the outlet (I) with a twist motion all the way to the
stop.
- Adjust the length of the extension shaft (o) if necessary. Pay attention to the
marking “max 1.65m” on the extension shaft. Tighten the sleeve (I) after
assembling/adjusting the extension shaft.
Dust suction ⑤
- Loosen locking knob for length adjustment I by turning it in the direction of the
unlocking symbol on the tool handle.
- Insert Vacuum hose P into the end of the tool handle as illustrated.
- Tighten Locking knob for length adjustment I by turning it in the direction of the
locking symbol on the tool handle.
- Connect the Vacuum hose with the Ø 47 mm adapter P4 directly to an industrial
vacuum cleaner (remove vacuum cleaner hose first).
- One may also connect vacuum hose with one of the 3 adapters to an industrial
vacuum cleaner without removing the vacuum cleaner hose.
Tool standard/airflow control ⑧
- Tool handle P1 prevents the hose from damage when putting the tool aside
during work breaks.
- Control the airflow by sliding suction power adjustment ring P3 over the
opening in tool connector P2.
- The vacuuming power is at its lowest level when the opening is fully visible.