Viking MI 632, Инструкция по эксплуатации, Страница: 114 / 428

0478 131 9931 B - EN
112
Insert the perimeter wire (1) into the cable
guides in the floor plate and guide it
through the socket (2).
Cut the ends of the perimeter wire (1) to a
free length of approx. 10 cm.
Fasten the press fit connectors (H) onto
the cable ends using suitable pliers –
ensure correct engagement.
Position the perimeter wire (1)
within the two markings (2).
Attach the connector (3) to both
pins (4) as shown. Ensure correct
connection of the left and right perimeter
wire ends – do not interchange the wire
ends.
Close the cover of the cable duct (5).
● After completing this installation
work, press the OK button on the
control panel.
Fit the cover as described in the "Installing
the docking station" section. (
Ö
9.5)
Then press the OK button on the
control panel.
Precisely observe the free length
and do not roll up protruding wire
ends. Excessively long free ends
can interfere with correct operation
of the robotic mower.
The press-fit connectors are
intended for one-time use and must
not be reused following removal.
Additional press-fit connectors are
available from a VIKING specialist
dealer. (
Ö 17.)