11
2. Unit Name
3. Mute Current / Next Alarm
4. Phone Firmware
5. IP Firmware
Up to a 31 character phone name can be assigned to the
K-1900-6/7-IP
being programmed. Often times the building
name and entrance location near the unit are used for the name.
A network failure alarm will be indicated by flashing the ”SIP Alarm LED” (located on PCB) and providing 3 beeps every
30 seconds in the handset of the
K-1900-6/7-IP
. A network failure indicates the unit is not registered to the SIP server
or there is a communication failure with the gateway. The three beeps can be muted by clicking on the “Mute Current /
Next Alarm”.
If new
K-1900-6/7-IP
firmware is available, after opening the programming software a pop window will ask if you would
like to update firmware. Another way to update is accomplished by clicking the phone firmware “Update” button. You
can then browse to the folder that contains the HEX file for updating the unit’s firmware. This method is typically only
used when Viking Technical Support has sent you updated firmware.
If new
K-1900-6/7-IP
firmware is available, after opening the programming software a pop window will ask if you would
like to update firmware. Another way to update is accomplished by clicking the IP firmware “Update” button. You can
then browse to the folder that contains the PIP file for updating the unit’s IP firmware. This method is typically only used
when Viking Technical Support has sent you updated IP firmware.
6. Import/Export
The Import/Export feature is useful for backing up all the
K-1900-6/7-IP’s
programming or for importing programming
when installing multiple units with a majority of the same programming.
Clicking on the “Clear Phone settings” button in programming will reset all of the Programming Features back to their
factory default settings.
Note:
This command will not change or reset your IP settings or phone numbers.
7. Clear Phone Settings
9. Diagnostics
The Diagnostics section in the
K-1900-6/7-IP
Programming can be used to test the status & functionality of the relay.
Clicking on the “Clear IP Settings” will reset IP setting only.
Note:
This command will not change or reset your phone
settings or phone numbers.
8. Clear IP Settings
The phone number programmed in the first location is the number that is dialed when the ”
K-1900-6/7-IP
” goes off
hook. Additional numbers will be dialed when there is no answer or a busy signal is detected. The
K-1900-6/7-IP
phone
is factory set with no phone numbers programmed. These phone numbers can be up to 20 digits.
1. Phone Numbers (1-5)
Programming Features
