2.
SET UP
21
WIND THE BOBBIN
4. Push the bobbin to the right.
5. Hold the thread end and press the foot
control. After a few turns of the bobbin,
cut off the thread end. When the bobbin
is full it will stop rotating. Push the
bobbin winder to the left and remove the
bobbin. Cut off the thread.
Place the Bobbin in the Machine
Turn off the main switch
1. Make sure that the needle is fully
raised before inserting or removing
the bobbin. Open the bobbin cover by
moving the release button to the right
(A). Remove the cover (B).
2. Place the bobbin in the bobbin case
so that the thread is running in a
counterclockwise direction.
3. Pull the thread though the slit and pull it
towards the left into the tension.
4. Pull the thread so that you have about
6 inches (15cm) of thread. Replace the
bobbin cover plate.
1.
4.
3.
2.
B
A
C
B
A
1. Pull the vertical spool pin up (A). Place a
large spool cap on the spool pin and place
the thread on the spool pin.
2. Bring the thread under the thread tension
disk (B) and around clockwise.
3. Insert the thread though the hole in the
bobbin from the inside to the outside.
Place the bobbin on the bobbin winder
spindle with the free end of the thread at
the top.
