3
Installation and Specifications
0.35 Diameter
(2 places)
Use 5/16" bolt
and flat washer
(included)
Rain Guard
(included)
SL-2
Strobe/
Beacon
Adhere gasket to chassis,
centering over mounting holes
4.750
0.75
6.0
4.000
1.000
0.325
5.400
3.0
3.00
3.12
4.750
0.125
5.000
0.75
35.760
1.25
1.50
0.875 Dia.
4.500
0.250
2.87
1.37
1.50
0.125 Diameter
Condensation
Drain Hole
Knockout for
1/2 inch conduit
42.0 in.
(± 0.1)
42.0 in.
(± 0.1)
Self-clinching
nut 6-32
(8 places)
Side View
Back View
CALL
CONNECTED
PUSH FOR
VIKING
©
HELP
Front View
Phone
Panel
Strobe Panel
Bottom
View
Adhere gasket to chassis,
centering over mounting holes
“ASSISTANCE” on models
E-1600A-AST-EWP
E-1600A-AST2EWP
or
“EMERGENCY” on models
E-1600A-BLT-EWP
E-1600A-BLT2EWP
“ASSISTANCE”
on models
E-1600A-AST-EWP
E-1600A-AST2EWP
or
“EMERGENCY”
on models
E-1600A-BLT-EWP
E-1600A-BLT2EWP
A
S
S
I
S
T
A
N
C
E
A
S
S
I
S
T
A
N
C
E
Attention
: To make sure water drain
notch between stobe and panel is
facing down, attach strobe panel with
wire exiting left side of panel.
Step 1.
Mount the tower phone approximately 42” above the floor to a flat, sturdy surface using 5/16 hardware.
Note:
Flat
washers should be used on the main mounting bolts for additional strength.
Step 2.
Locate the strobe light panel and attach red, black and green 42” wire extensions with butt connectors then pass the red,
black and green wires from the strobe panel through the gasket and the upper hole in the tower.
Step 3.
Mount the strobe panel to the tower using the four security screws provided.
Attention:
To make sure water drain notch
between stobe and panel is facing down, attach strobe panel with wires exiting left side of panel.
Step 4.
Locate the phone panel. Using the gel-filled butt connectors, connect the red, black and green wires labeled “Strobe Light”
to the red, black and green wires on the strobe panel.
Step 5.
Connect the phone line to the red and green wires (this connection is not polarity sensitive).
Step 6.
Connect the 12V DC adapter wires (-) and (+) to the black with red stripe (-) and red with black stripe (+) wires from the
BLK-4
control module.
Step 7.
Mount the phone panel to the tower using the remaining four security screws.
