Viking Designer DDFB304, Сервисный журнал, Страница: 41 / 48

40
Icemaker (All Freezer Only)
Before replacing icemaker, use this guide to determine if icemaker is defective
To avoid electrical shock, which can cause severe personal injury or death, disconnect power to
unit using power switch before servicing. Wires removed during disassembly must be replaced
on proper terminals to insure correct earth ground and polarization. After servicing, reconnect
power using power switch.
CAUTION: To avoid property damage, test for water leaks after repair or replacement
of icemaker, water valve, filter, or supply lines and valves. Do not over tighten
connections to household water supply.
NOTE: THIS INFORMATION IS DESIGNED TO ASSIST QUALIFIED
PERSONNEL ONLY. UNQUALIFIED PERSONS SHOULD NOT ATTEMPT
REPAIRS DUE TO POSSIBILITY OF ELECTRICAL SHOCK.
Specifications:
•
Use SxS Style Icemaker only
•
Electrical – 115 VAC, 50/60 HZ
•
Mold Heater – 165 Watts, 73-85 ohm
•
Water Valve Ohm – 180-200 ohm
•
Thermostat – Close: 15 º F ± 3º F, Open: 48º F ± -6º F
•
Water Pressure Needed – 20-120 psi.
•
Water Fill Volume – 120cc (4.2 oz.)
•
Water Fill Time – 6.6 to 7.2 seconds
THERMAL CUT-OUT (TCO)
The TCO is a safety device and must NOT be bypassed. If TCO is found to be
electrically open, the cause must be found and corrected before replacing Icemaker. The
TCO is most likely open if there is no continuity between the black and white wires of
the icemaker cable with the ejector in any position other than the park position (ejector
blades horizontal pointing toward back of icemaker.