Gas and Electrical Connection
GAS CONNECTION
Verify the type of gas supply to be used,
either natural or LP, and make sure the
marking on the grill rating plate agrees with
that of the supply. Never connect an
unregulated gas line to the appliance. An
installer supplied gas shut-off valve must be
installed in an easily accessible location. All
installer supplied parts must conform to local
codes, or in the absence of local codes, with
the National Electrical Code, ANSI/NFPA 70
and the National Fuel Code, ANSI
Z223.1/NFPA 54.
In Canada:
Installation must be in
accordance with the current CSA-B149.1,
Natural Gas Installation Code or CSA-
B149.2, Propane Installation Code and/or
local codes. All pipe sealants must be an
approved type and resistant to the actions of
LP gas. Never use pipe sealant on flare
fittings. All gas connections should be made
by a competent technician and in
accordance with local codes and or
ordinances. In the absence of codes, the
installation must comply with the National
Fuel Gas Code ANSI Z223.1/NFPA 54. The
gas grill and its individual shut-off valve must
be disconnected from the gas supply piping
system during any pressure testing of that
system at test pressures in excess of 1/2
PSIG (3.5 kPa). The gas grill must be isolated
from the gas supply piping system by
closing its individual manual shut-off valve
during any pressure testing of that system at
test pressures equal to or less than 1/2 psi
(3.5 kPa). Built-in installations must be
plumbed using a fixed/hard line if the unit is
going to be operated at a distance
exceeding 3 feet (0.91 meters) from the fuel
supply per ANSI Z21.24 CSA.
GAS CONVERSION
To convert a grill from natural to
LP/Propane or LP/Propane to natural, you
MUST use conversion kit sold seperately.
ELECTRICAL CONNECTION
21
WARNING
DANGER
CAUTION
FOR YOUR SAFETY
Conversions should only be performed by an
authorized service technician.
WARNING
ELECTRICAL SHOCK HAZARD
This appliance is equipped with a 3’
(91.4 cm) 3-prong power cord with a
grounding plug for your protection
against shock hazard and should be
plugged directly into a properly grounded
receptacle. Do not cut or remove the grounding
prong from this plug. This unit is not fused and
installer must install a GFI. Unit must be
grounded in accordance with local codes or with
the National Electrical Code ANSI/NFPA 70, or
the Canadian Electrical Code, CSA C22.1.
Ventilation for Built-In Installations When
Using an Enclosed LP-Gas Cylinder
20
Vents
1.00 inch maximum
5.00 inch
maximum
All vents no more than 5.00 inches
above the floor of the installation.
5.00 inch
maximum
Not more than 5.00
inches from inside
bottom of countertop.
Bottom Vent not
more than 1.00 inch
from inside floor of
installation.
An enclosure for an LP-gas cylinder shall be ventilated by openings at both the upper and lower
levels of the enclosure. The effectiveness of the opening(s) for purposes of ventilation shall be
determined with the LP-gas supply cylinder in place. This shall be accompanied by one of the
following:
a.
One side of the enclosure shall be completely open; or
b. For an enclosure having four sides, a top and a bottom:
1. At least two ventilation openings (See Part IV, Definitions) shall be provided in the side
walls of the enclosure, located within 5 in. (217 mm) of the top of the enclosure, equally
sized, spaced at a minimum of 90 degrees (1.57 rad), and unobstructed. The opening(s)
shall have a total free area of not less than 1 in
2
/lb (1.42 cm
2
/kg) of stored fuel capacity.
2. Ventilation opening(s) shall be provided at floor level at rear of the enclosure and shall
have a total free area of not less than 1/2 in
2
/lb (7.1 cm
2
/kg) of stored fuel capacity. The
bottom of the openings shall be 1 in. (25.4 mm) or less from the floor level and the
upper edge no more than 5 in. (127 mm) above the floor level. The openings shall be
equally sized, spaced at a minimum of 90 degrees (1.57 rad) and unobstructed.
3. Every opening shall have minimum dimensions so as to permit the entrance of a 1/8 inch
(3.2 mm) diameter rod.
4. Ventilation openings in the side walls shall not communicate directly with other
enclosures of the outdoor cooking gas appliance.
Vents located
on sidewall
Содержание 30inch 500 VGBQ
Страница 18: ...35 34 ...
