Viking Range DCH3042, Руководство по установке

Страница: 2 / 12

NOTE: Includes Recirculating Hood Kit
Installation Instructions
(See page 5)
NOTE: IF INSTALLING HOOD WITH
WARMING SHELF PANEL, INSTALL
WARMING SHELF PANEL FIRST.
IMPORTANT - PLEASE READ AND FOLLOW
•Before beginning, please read these instructions completely
and carefully.
•Do not remove permanently affixed labels, warnings, or
plates from the product. This may void the warranty.
•Please observe all local and national codes and ordinances.
If no local codes are applicable, wire in accordance with the
National Electrical Code, ANSI/NFPA 70-1990.
• The installer should leave these instructions with the
consumer who should retain for local inspector’s use
and for future reference.
This hood is for residential installation only and is not
designed for installation over a commercial product. Make
sure power is off at the main circuit breaker or fuse box before
making connections.
To avoid risk of fire, electric shock, or
injury to persons, turn off the electricity to the hood from
the power supply before servicing or cleaning.
Viking hoods are equipped with variable speed controls
for blowers. These units will not function with a single
speed ventilator. All Viking ventilator kits are designed
specifically for use with Viking hoods. Use of any non-
Viking ventilator kit will void the hood warranty.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK,
OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
2. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer’s guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American Society
for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
3. When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
4. Ducted fans must always be vented to the outdoors.
5.
WARNING!: To reduce the risk of fire, use only metal
ductwork.
6.
CAUTION!: To reduce risk of fire and to properly
exhaust air, be sure to duct air outside. Do not vent
exhaust air into spaces within walls or ceilings, or into
attics, crawl spaces, or garages.
CAUTION
For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRICAL
SHOCK, OR INJURY TO PERSONS, RANGEHOODS
MUST BE INSTALLED WITH THE VENTILATORS
THAT ARE SPECIFIED ON THEIR CARTON
INDICATING SUITABILITY WITH THIS MODEL.
OTHER VENTILATORS CANNOT BE SUBSTITUTED.
2