Viking Range CVGRT736, Инструкция по использованию и уходу

Страница: 7 / 16

7
Our rangetops are equipped with an exclusive restaurant style sealed burner system. This unique burner system is equipped
with 23,000 BTU front burners, 15,000 BTU rear burners and one 8,000 BTU rear burner.
The 23,000 BTU burners are designed to provide extra high heat output, expecially when using large pans, and should be used
for boiling large quantities or to bring something to a boil quickly. While the high output 23,000 BTU burners have the extra
power needed to bring large quantities of liquid to a boil rapidly, they are also able to be turned down low enough to provide a
very low and delicate simmer, making this the most versatile burner system on the market.
Lighting Burners
All burners are ignited by electric ignition. There are no open-flame, “standing” pilots.
Surface Burners-Automatic
Re-ignition
To light the surface burners, push and turn the appropriate control knob counter clockwise to any
position. This control is both a gas valve and an electric switch. Each burner will ignite at any
“ON” position with the automatic re-ignition system. If the flame goes out for any reason, the
burner will automatically re-ignite if the gas is still flowing. When gas is permitted to flow to the
burner, the electric igniters start sparking, creating a “clicking” sound. If not, turn off the control
and check that the unit is plugged in and that the fuse or circuit breaker is not blown or tripped.
Within a few moments, enough gas will have traveled to the burner to ignite. When the burner
ignites, turn the burner control to any position to adjust the flame size. Setting the proper flame
height for the desired cooking process and selecting the correct cooking vessel will result in
superior cooking performance, while also saving time and energy.
Surface Operation
Operation
locator graphic
locator pin burner base notch
Proper alignment of Burner Head
When placing the burner head on the burner base,
carefully align the locator pin in the outer edge below
the burner ports with the small notch in the top front
edge of the burner base. This will align the burner
port with the ignitor. When properly installed, the
locator graphic will be aligned with the ignitor and
opposite the locator pin.