3/4
The Motor-X and Motor-Y interface on board should be connected to the X-Part and Y-part
motors correspondingly. The 6Pin of the motor wire is for the motor, and the 4Pin is for the control
panel.
Please connect the laser to the control board with the 3pin wire. Connect the side board to the
main control board. And Connect the power supply and the computer with the USB cable.
Please focus the laser on the materials to be carved referring to the laser instructions below before
starting carving.
3.2 Instructions for laser.
Please wear the protective glasses before operating the laser!
When all the connections are completed, turn on the power, and the laser is standby for working.
The red light on the top of the laser is continuous lighting at this time.
Turn on the weak light and adjust the focal length
Please lay the materials to be carved flat under the laser. The recommended distance from laser
outlet to materials is 5~10cm. Out of range may be out of focus.
Press the weak light switch on the top of the laser (Marked as
). Then the red light will flash and
the weak light on. Laser spots can be seen on the materials to be carved at this time. Rotate the
focusing ring slowly on the laser outlet to shrink the laser spots. When the laser spots are minimized, it
is the optimum state for laser carving.
After that, press the weak light switch again, and the weak light is turned off. The red light on the
top of the laser is continuous lighting at this time, and the laser is standby for working.
It is important to understand that this weak light switch on the top of the laser is not controlled by
control software.
So be sure to switch back to normal (make sure that weak light is off) before you start
carving.
4. Notice and FAQ
(1).The shape of all parts above in this description is only as a sign. There may be a difference
between the actual parts and the parts in the installation instructions. Please refer to the shape of
the actual parts purchased.