26
3 Design and Function
6.
When test is completed, the display shows
the results as following {Press the
|
}
key to
select: SOH (STATE OF HEALTH) or SOC (STATE OF
CHARGE)}.
GOOD & PASS
XX.XXV XXXXSAE
GOOD & PASS:
The battery is good & capable
of holding a charge.
GOOD & RECHARGE
XX.XXV XXXXSAE
GOOD & RECHARGE:
The battery is good but needs to
be recharged.
RECHARGE & RETEST
XX.XXV XXXXSAE
RECHARGE & RETEST:
Battery is discharged. The bat-
tery condition cannot be deter-
mined until it is fully charged.
Recharge & retest the battery.
BAD & REPLACE
XX.XXV XXXXSAE
BAD & REPLACE:
The battery will not hold a char-
ge. It should be replaced imme-
diately.
BAD CELL & REPLACE
XX.XXV XXXXSAE
BAD CELL & REPLACE:
The battery has at least one
cell short circuit. It should be
replaced immediately.
7.
End of test. Proceed the printout if needed.
NOTE
that there might be some messages
displayed to different circumstances as below.
LOAD ERROR
LOAD ERROR:
The tested battery is bigger than
2000SAE (CCA). Or the connec-
tion is not properly established.
Check the capacity of the battery & make sure the
clamp lead is properly connected.
Содержание V3748
Страница 34: ......
