Vigilant HumiDoor 75, Руководство пользователя

Страница: 12 / 16

Vigilant Inc. Reliance End Table Owner’s Manual, Page
MAINTENANCE
1. Your Vigilant cigar cabinet is more than just a cigar humidor; it is a fine piece of
handcrafted furniture. Regularly dust the exterior of the cabinet by spraying a soft
cloth and a product like Endust. Please do not spray your cabinet with furniture polish,
as the polish will eventually build up and dull the beautiful hand- finish on the cabinet.
2. When the RED time -to-fill LED or LOW WATER alarm is on, it is time to fill the water
tray with distilled water. Frequency of filling will depend on ambient conditions.
3. You will find a trap door on the inside of your cabinet. Lifting up this panel will provide
access to the water tray. Pour distilled water in the large front cutout of the water tray
until the alarm goes out.
DO NOT overfill the water tray or pour water on any of the
electronics.
4. Be sure to keep boxes free from the fan in the back as well as the front grommet
holes. Failure to do so could cause issues with humidity levels.
Never move the cabinet when water is in the water tray.
Never pick the cabinet up by its top.
CLEANING THE RESERVOIR AND WICK
As both the reservoir and wick are constantly exposed to moisture, and the wick is exposed
to dirt and other airborne particles, they must be cleaned periodically. It is recommended
that you check the water and reservoir at least once every three months.
1.
It is advised to unplug your cabinet prior to cleaning the reservoir and wick.
2.
Lift the trap door and secure in position with the lever on the sidewall of the
cabinet. You will need to remove all water from the water tray and remove the
wicking filter.
3.
Once the trap door is opened and secured with the clip, unplug the float switch. If
there is any remaining water in the water tray, it can be removed with a sponge.
4.
The reservoir can then be removed from the cabinet for cleaning. You can open the
reservoir by the 2 clips on the side of the box. Rinse thoroughly with warm water and
dish soap. DO NOT USE BLEACH. The wicking filter can be rinsed and used again. If the
wicking filter does not wash clean, it should be replaced. It is recommended to replace
the wicking filter every 3-4 months.
5.
Put the reservoir back in its place and reconnect the float switch wire. Once wicking
filter is back in place, lower trap door while making sure no wires are in the way.
6.
You can now plug your cabinet back in.
IF WATER IS SPILLED WHILE REFILLING THE RESERVOIR,
DO NOT PLUG YOUR CABINET BACK IN UNTIL IT IS COMPLETELY DRY.
PLUGGING THE CABINET IN BEFORE IT IS DRY COULD CAUSE FAILURE
OF THE CONTROLLER AND OTHER ELECTRONIC COMPONENTS