4.) Turn the system on by plugging the power strip cord leaving the back of your
ClimaCab into a 110V AC household outlet. The red time-to-fill LED will illuminate
immediately. Make sure that the wicking filter is sitting vertically upright in your
water reservoir.
5.) Slowly fill the water reservoir with DISTILLED water until the red time-to-fill LED
turns off. Slowly add 2½ cups (20 ounces) more water after the LED shuts off. The
reservoir is outfitted with an overflow vent that will dispense water into your
ClimaCab rather than into the electronics compartment. Add a couple drops of
bacteriostat each time you fill. You can purchase it by scanning the QR code at the
end of this document. DO NOT OVER FILL THE RESERVOIR, AS OVERFILLING WILL
CAUSE WATER DAMAGE TO YOUR CLIMACAB! DO NOT POUR WATER ON THE
FAN IT MAY CAUSE DAMAGE TO THE ELECTRONICS.
Operating the Sentry Humidification System
1.) Allow the Sentry Humidification System to operate at the pre-set level for at least
1 hour before adding instruments to your ClimaCab. The initial digital reading will be
much lower than 50%, but will rise upon starting the system.
2.) The system will consume large quantities of water during the seasoning stage of
the first 24-48 hours as the instruments and ClimaCab come to equilibrium.
Therefore, it is important to keep the reservoir filled at all times.
3.) The Sentry Humidification System requires that you adjust the humidity level in
response to the independent LCD hygrometer. Close your ClimaCab door(s) and
allow the system to run for several hours. When the fan stops running, the system
has reached the set-point level and you should now note the humidity reading on
your hygrometer.
4.) It is recommended that you do not set the humidity level above 50%, as
instruments stored at humidity levels higher than 55% can start to exhibit issues with
over humidification.
