3
Installation Instructions
Visit the ViewZ USA website at http://www.viewzusa.com
VZ-DC24-320 Power Supply
PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS MUST BE READ AND COMPLETELY UNDERSTOOD. KEEP THESE
INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE REFERENCE.
Minimum screw size - 2 1/4" length, 0.117" (11/64) thread diameter, 0.4" head diameter
Wire - 14AWG
~
18 AWG with temperature tolerance of 105c
The following tools may be required depending on your installation.
Electronic Stud Finder
Level
Protective Eye-wear
Screwdriver
Pencil
Portable Drill
Drill Bit
Wiring and Mounting of Power Supply must be done by a trained and authorized service technician.
UL Installation Requirements
Power Supply should be mounted on wall with a flat service in an area designated for authorized personnel only.
Do not apply power to unit until mounting and all connections are made.
Only use copper wire for output cabling. The type of wire and its rated Ampacity are determined using NEC ANSI/NFPA 70 Article 310.
Do not install near water, high moisture, open flames or sources of high levels of heat.
The wire’s rated Ampacity for output cabling must be derated by multiplying by 0.8 as specified in ANSI/NFPA Article 645.5A.
Power output cabling must be housed within a cable tray, conduit, or plenum area for continuous protection to the cabling.
Always crimp a UL listed ring terminal to each wire according to the ring terminal manufacturer’s instructions.
It is recommended that a maximum of ⅝˝ plaster board be used when mounting to wooden studs.
Be aware of the mounting environment. If drilling and/or cutting into the mounting surface, always make sure that there are no electrical wires in
wall. Cutting or drilling into an electrical line may cause serious personal injury.
Make sure there are no water or natural gas lines inside the wall where the mount is to be located. Cutting or drilling into a water or gas line may
cause severe property damage or personal injury.
Contact ViewZ with any questions:
(888) 998-4399
It is recommended that a maximum of ⅝˝ plaster board be used when mounting to wooden studs.
Warning Statements
Field Wiring and Mounting Instructions
