39
4. Press
to select the item you want to modify and press
ENTER
on the projector
or
Enter
on the remote control.
5. Press
/
to move the cursor and the enter the value.
6. To save the settings, press
ENTER
on the projector or
Enter
on the remote
control. If you do not want to save the settings, press
MENU/EXIT
on the projector
7. or
Menu
on the remote control.
8. Press
to highlight
Apply
and press
ENTER
on the projector or
Enter
on the
remote control.
Important
•
If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default
Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
•
If you wish to connect to the projector in its standby mode, be sure you have selected
RJ45 and obtained the IP Address, Subnet Mask, Default Gateway, and DNS information
when the projector is on.
Wireless connection
To connect to the projector wirelessly, you have to plug a ViewSonic wireless dongle
(optional) to the Type A USB connector on the projector, and then only a few OSD
configuration steps are required.
1. Make sure the projector is turned on.
2. Press
MENU/EXIT
on the projector or
Menu
on the remote control and then go to
Setting > LAN Control Setting
menu.
3. Highlight
Wireless LAN
and press
ENTER
on the projector or
Enter
on the remote
control.
4. Make sure the
Status
is
Connect
.
5. Make sure the
SSID
information is displayed.
6. In
AP
mode, you need to use your computer’s wireless connection utility to search
the projector’s SSID and connect to it. The password of connection the Wi-Fi for
the first time is “87654321”. Then you can search the projector with vsPresenter.
To use
Client
mode, you should connect both your computer and projector to the
same AP router and make connections with the IP address.
ViewSonic wireless dongle
P/N: WPD-100
Содержание PJD6345
Страница 58: ...51 Slideshows Photo slideshow duration time includes 2 sec 5 sec and 10 sec...
Страница 86: ......
