32
4.
Highlight
DHCP
and press
/ to select
On
.
5.
Press
to highlight
Apply
and press
Enter
.
6.
Please wait for around 15 - 20 seconds, and then re-enter the
Wired LAN
page. The
IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS Server
settings will be
displayed. Note down the IP address displayed in the
IP Address
row.
If the IP Address still does not appear, contact your network administrator.
If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default Gateway,
and DNS Server settings will display 0.0.0.0. Make sure the cables are properly connected and
perform the procedures above again.
If you need to connect to the projector in its standby mode, set Enable Network Standby Mode
to On in the SYSTEM SETUP: Advanced > Standby Settings > Network menu.
If you are in a non-DHCP environment:
1.
Repeat steps 1-3 above.
2.
Highlight
DHCP
and press
/ to select
Off
.
3.
Contact your ITS administrator for information on the
IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS Server
settings.
4.
Press
to select the item you want to modify and press
Enter
.
5.
Press
/ to move the cursor and the press
/
to enter the value.
6.
To save the settings, press
Enter
. If you do not want to save the settings, press
Exit
.
7.
Press
to highlight
Apply
and press
Enter
.
If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default Gateway,
and DNS Server settings will display 0.0.0.0. Make sure the cables are properly connected and
perform the procedures above again.
If you wish to connect to the projector in its standby mode, be sure you have set DHCP to Off
and obtained the IP Address, Subnet Mask, Default Gateway, and DNS Server information
when the projector is on.
Controlling the projector through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby
mode, you can use any computer that is on the same local area network to control the
projector.
If you are using Microsoft Internet Explorer, make sure it is version 7.0 or higher.
The screen shots in this manual are for reference only, and may differ from the actual design.
1.
Enter the address of the projector in the address bar of your browser and press
Enter
.
Содержание LS620X
Страница 77: ......
