7
Initial start−up, inspection and maintenance
Further details regarding the individual steps
(cont.)
Oil pressure adjustment and vacuum check
The oil pressure is preset at the factory according to the oil throughput.
Adjust the oil pressure, if necessary.
1.
Isolate the mains electricity supply
and safeguard against
unauthorised reconnection.
2.
Unscrew drain plugP
A
from the
oil pump.
3.
Unscrew drain plugV
B
from the
oil pump.
Note
This allows the oil to drain from
the oil pump.
4.
Insert a pressure gauge (range
0
25bar) and a vacuum gauge
(range 0
1bar).
Note
Seal the pressure and vacuum
gauges only with copper or
aluminium gaskets or O rings
.
Never use PTFE tape.
5.
Start up the burner.
Note
The solenoid valve opens.
6.
Read off the oil and vacuum
pressures of the pump on the
relevant gauges (vacuum should
be max. 0.35bar given a head of
3m between the oil pump and the
bottom of the tank).
Note
Where vacuum measures higher
than 0.35bar, check filter for
cleanliness or pipe run.
5692589GB
Danfoss oil pump, typeBFP31
Suntec oil pump, typeALE35
C
A
B
A
B
C
Содержание VEK
