Viega 8174.1, Инструкция по использованию и техническое описание

Страница: 7 / 10

3 Handling
3.1 Assembly information
3.1.1 Required tools
The following tools are required for mounting:
n
fork or ring spanner: 17 mm / 19 mm
n
socket wrench: 17 mm
n
Allen key: 5 mm
n
Phillips-tip screwdriver
n
slotted screwdriver
n
silicone press
n
For disposal preparation: drill with 2 or 3 mm drill bit
3.2 Assembly
3.2.1 Replace gas pressure spring
The model replaces the built-in gas pressure spring in the case of a
defect.
NOTICE!
Damage to the cover plate!
If the upper edge of the finished floor is higher than
planned, there is a risk that the cover plate will touch. To
avoid touching, limit the lowering of the WC (possible up to
a max. of 20 mm):
– Place a maximum of five 4 mm spacer washers (included
in scope of delivery) under the piston rod of the gas
pressure spring.
Requirements:
n WC ceramic is at the lowest position
n Following components are removed (see instructions for use of the
cover plate 8356.8):
– WC ceramic
– cover plate
– actuating button / hydraulic actuation
– cover frame
Handling
Viega Gas Pressure Spring 7 from 10