The press jaw must be able to lock properly during
pressing.
n
Ensure that there is enough space on the press point.
n
Keep the press jaw contour and the area around the
press point free from dirt and any objects that could
hinder complete pressing.
Requirements:
n
The press machine is ready for operation, the green LED is illumi‐
nated.
n
A press jaw has been correctly inserted.
▶
Check whether the nominal width of the press connector matches
the nominal width of the press jaw.
▶
Fit the press machine with the press jaw inserted accurately and at
a right angle to the pipe axis on the press connector.
▶
Keep the Start button pressed until the automatic process starts.
▷
Once the press machine creates the press force, it automatically
completes pressing from this point until the entire press stroke
has been carried out.
▶
After full retraction of the roller head, open the press jaw and loosen
it from the press connector.
In case of interruption of the power supply during
pressing, press the manual release button to return the
roller head to its initial position.
Then remove the incompletely pressed press connector
from the installation and use a new press connector.
3.4
Aborting the pressing process
If the roller head has not yet touched the press jaw and the press
machine has not yet built up any pressing force, the pressing process
can simply be aborted by releasing the Start button.
Next, press the button to manually release and bring roller head back to
its starting position.
If the press machine is in automatic mode, the pressing can only be
aborted by pressing the button to manually release.
3.5
Troubleshooting
In case of malfunction, check the following potential causes:
90°
Handling
Press machinePressgun 5
17
